Porter-Cable MS200 Manual do Utilizador

MEDIUM CROWNSTAPLERInstructionmanualThe Model and Serial No. plate is located on the mainhousing of the tool. Record these numbers in thespaces below

10Keep fingers AWAY from trigger when not drivingfasteners to avoid accidental firing. Never carry tool with finger on trigger. In “Contact Actuation

11CLEAN AND INSPECT DAILYDisconnect tool from air supply before cleaning andinspection. Correct all problems before placing the tool back in use.Wipe

122. Tool does nothing or Inadequate air supply. Verify adequate air supply.operates sluggishly. Inadequate lubrication. Put 5 or 6 drops of oil into

The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE •DELTA S.A.) (Lesmarques suivantes sont des

2Matthew G. PopikVice President of EngineeringPORTER✦✦CABLEPorter-Cable Corporation4825 Highway 45 NorthJackson, TN 38305Date of Manufacture:_________

3indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.indicates a potentially hazardous situation

4Fig. 6Fig. 5Fig. 2Fig. 3Fig. 41. Read and understand tool labels andmanual. Failure to follow warnings couldresult in DEATH or SERIOUS INJURY. Fig. 1

59. Do not connect tool to pressure whichpotentially exceeds 200 PSI (13.7 BAR).10. Only use air hose that is rated for amaximum working pressure of a

621. Remove finger from trigger when notdriving fasteners. Never carry tool with fingeron trigger. In “Contact Actuation Mode” toolwill fire a fastene

7Employer must enforce compliance with the safety warningsand all other instructions contained in this manual.Keep this manual available for use by al

8Only use approved Porter-Cable fasteners.Operator and others in work area MUST wear safety glasses with side shields. Always wear ANSI Z87.1 approved

9USING THE TOOL WITH SELECTABLE TRIGGERING OPTIONSComplete all steps of PREPARING THE TOOL before using the tool.This tool is shipped from the factory