Porter-cable RN175 Manual do Utilizador

ROOFING COILNAILERInstructionmanualThe Model and Serial No. plate is located on the mainhousing of the tool. Record these numbers in thespaces below a

10DANGER: Keep fingers AWAY from trigger when not drivingfasteners to avoid accidental firing. Never carry tool with finger ontrigger: tool will fire

11MAINTENANCECLEAN AND INSPECT DAILYWARNING: Disconnect tool from air supply before cleaning andinspection. Correct all problems before placing the to

12PORTER-CABLE LIMITED ONE YEAR WARRANTYPorter-Cable warrants its nailing and stapling tools for a period of one year from the date of originalpurchas

The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE •DELTA S.A.) (Lesmarques suivantes sont des

2Matthew G. PopikVice President of EngineeringPORTER✦✦CABLEPorter-Cable Corporation4825 Highway 45 NorthJackson, TN 38305Date of Manufacture:_________

3GENERAL SAFETY RULESDANGER: When using pneumatic tools, basic safety precautionsshould always be followed to reduce the risk of personal injury, incl

47. Wear ear protection to safe-guardagainst possible hearing loss. Fig. 5.8. Use clean, dry, regulated, com-pressed air at 70 to 120 PSI, (4.8 to 8.3

522. Do not overreach. Keep proper footingand balance at all times when using orhandling the tool. 23. Fire fasteners into work surface only:never int

6EMPLOYER’S RESPONSIBILITIESDANGER: Employer must enforce compliance with the safety warningsand all other instructions contained in this manual.Keep

7Fig. 19PREPARING THE TOOL1. After reading and understanding this entire manual, connect tool to air supply (Fig. 18).DANGER: Never point tool at your

86. Close magazine cover, close and latch feeder cover (see Fig. 23).7. Adjust directional exhaust deflector (A) Fig. 24, so that the exhaust airblast

9OPERATING INSTRUCTIONSUSING THE TOOL WITH SELECTABLE TRIGGERING OPTIONSComplete all steps of PREPARING THE TOOL before using the tool.This tool is sh