Porter-cable FC350 Manual do Utilizador

CLIPPED HEADFRAMING NAILERInstructionmanualThe Model and Serial No. plate is located on the mainhousing of the tool. Record these numbers in thespaces

10Keep fingers AWAY from trigger when not drivingfasteners to avoid accidental firing. Never carry tool with finger on trigger. In “Contact Actuation

11CLEARING A JAMMED FASTENERDisconnect tool from air supply.1. Remove any remaining fasteners from the nailer.A. Pull follower all the way to the rear

12CLEAN AND INSPECT DAILYDisconnect tool from air supply before cleaning andinspection. Correct all problems before placing the tool back in use.Wipe

13TROUBLESHOOTINGDisconnect tool from air supply before performing any Service Procedure.SYMPTOM PROBLEMS SOLUTIONS1. Air leak near top of Loose scre

14PORTER-CABLE LIMITED ONE YEAR WARRANTYPorter-Cable warrants its nailing and stapling tools for a period of one year from the date of originalpurchas

The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE •DELTA S.A.) (Lesmarques suivantes sont des

2Matthew G. PopikVice President of EngineeringPORTER✦✦CABLEPorter-Cable Corporation4825 Highway 45 NorthJackson, TN 38305Date of Manufacture:_________

3indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.indicates a potentially hazardous situation

4Fig. 6Fig. 5Fig. 2Fig. 3Fig. 41. Read and understand tool labels andmanual. Failure to follow warnings couldresult in DEATH or SERIOUS INJURY. Fig. 1

59. Do not connect tool to pressure whichpotentially exceeds 200 PSI (13.7 BAR).10. Only use air hose that is rated for amaximum working pressure of a

621. Remove finger from trigger when notdriving fasteners. Never carry tool with fingeron trigger. In “Contact Actuation Mode” toolwill fire a fastene

7Employer must enforce compliance with the safety warningsand all other instructions contained in this manual.Keep this manual available for use by al

8Do not load fasteners with trigger or safety depressed.Only use approved Porter-Cable fasteners.Operator and others in work area MUST wear safety gla

9USING THE TOOL WITH SELECTABLE TRIGGERING OPTIONSComplete all steps of PREPARING THE TOOL before using the tool.This tool is shipped from the factory